|Lazertoyz EZ Build model|
Yellow and Black only
The Fenix 80 is made of EPP an easy build. This Kit comes with the EPP Foam, 31" wingspan with pushrods and control horns installed , just cut the nose off 1" back with 2 degrees down and right thrust. Glue a mount on glue the elevator on and servos in.
What you will need is the following Power Pack.
12 amp esc
3mm prop saver
Prop- 6" to 7"
8 gram servos
450 to 1000 mAh 7.4V or 11.1V Lipo
landing gear kit
For Slope glider-
Battery pack to power rx and servos (4.5 to 6V )
(2) 8.5 gram servos
I have some 3 aaa battery holders that work great. you will need nose weight (battery pack placement works good . CG is at the wing spar
You will also need a Transmitter and receiver .