Lazertoyz

Remember Purchase over $60 and get FREE SHIPPING !

RC LIGHTING SYSTEMS                                          My T-28 Trojan

LOW COST "V2 and V3  LITE RC Lighting systems"

 

Want RC Lights ?

Plug the Lazertoyz RC LITE Controller into a receiver just like a servo the Gear works best then you can toggle through the light kits . Uses very low amperage from the 5 Volt power from your Receiver. Then you can use your R/C radio Transmitter to control the "RC LITE SYSTEM"

Low Power,  Extremely Bright. YES ! Switch or Joystick controllable while flying ! Turn on your lights while flying and your landing lights on final approach ..

Now how cool is that ?

 

CLICK HERE FOR LIGHT STRIP PAGES

 

 

 

 

The Lazertoyz V2 Light Kit is ready to use , it gives you control from your transmitter over the strobe (white) & position lights (Red and Green) turning them on & off solid or blinking along with the landing light (only one)  on and off.

 

Weight of the 4 Ultra bright LED system is only  .3 OZ - 10 grams       

Current draw with 6 lights on solid is  0.14 amps 

Click for Full  V2 RC LITE SYSTEM Lighting data Sheet   V2 Video

MODES AVAILABLE WHEN FLYING ****

1. Strobe Only - Solid on

2. Strobe - 3 blink

3. Strobe Solid On & Solid On Position Lights - Red &  Green

4. Blinking  Position Lights - Red &  Green & Blinking Strobe

5. Landing lights- solid on Red Green & Strobe Blinking

6. Landing lights- solid All Lights On Solid

 

 

Radio Controlled lighting system ready to plug into your receiver with 4 pre-wired 26" leads and  LED's

No extra Power required, runs on your receivers 5 or 6 volt system.

V2 RC Lite System $29.00

 

 V2 and V3 Kits

 

 

Light Kit small 30 awg wire for extending or connecting Lightstrips or LEDS

30 AWG Wire -   (equal length of yellow and white) 1.00 per foot (just order as many feet as you like it will be a continuous length) $1.00 per foot

Ultra small  3/64 Shrink tube for 30 awg wire  $1.00 per foot

 

V3 Kit with  5 LEDs  - 26" 30 awg wire leads on each LED

 5 LEDS - 25,000+ MCD ULTRA BRIGHT LED KIT

Transmitter controlled lights for you Rc Model

 

 

MODES AVAILABLE

WHEN FLYING ****

1. Strobe & Solid On Position Lights - Red &  Green

2. Strobe & Solid On Position Lights - Red &  Green and Landing Lights On- you can cycle back to #1

 

 

 5 Leds -1 Strobe,1 Red, 1 Green and 2 White Landing -

V3 RCLITES each Led as  26" wire lengths designed for wings under 42" wingspan. 56" wire version below.

 V3 ( this works best with you scale looking Aircraft ) JUST $32.00

Pre-wired LED RC Lights Specs for the V2 V3, and the MaxiLight Kit.

    red 25,000 MCD  25 deg angle

  green 25,000 MCD 25 deg angle

  white 55,000 MCD 25 deg angle

 One each of Red & Green position lights , and 2 white LED's (1-landing and 1- strobe) !

Add more LED's  for $2.00 each. Use up to 20 LED's

Additional Ultra Bright LED with 26" of 30 awg Wire

Pre-Wired and insulated to LED

  Pre-Wired LEDS Just $2.00 each

 

Just add in parallel with the same color light and wire yellow to yellow and white to white. Dont mix colors, mixing colors will cause one light to be less bright than the other or burn one out.

Wire Length

Colors

 NEW! V3 *   56" wire RC LITE KIT

 

 5 LEDS - 25,000+ MCD ULTRA BRIGHT LED KIT

1 Strobe,1 Red, 1 Green and 2 White Landing - V3 RC LITES 56" Lite Kit for Large Planes with 56" wire lengths -

NOW LIGHTING FOR THOSE 80" CUBS and Planes up to -100" wingspan

JUST $39.00

Yes ! you can Add more Lights Click Below for video

 How to add more LED's

New MAXI-LIGHT KIT < click for YouTube video

Custom Configure your  lights !

Limited quantities available    $29.00 each

50-57-9002Set of 10 connectors ( Picture to Left)  included in Kit works with most LEDS 2.2 V to 3.2 V up to 1 watt no resistor required

Kit can work on a 3 position switch or Low to High or medium to high using your sub trim. Positions are indicated in the columns below

 

 

 

Channel

Low -100 (1ms)

Center 0 (1.5ms)

High +100 (2ms)

 

OUTPUT

       

1

 

Solid On

Solid On

 

2

   

Solid On Landing

 

3

 

Solid On

Solid On

 

4

Solid On

Solid On

Solid On

 

5

 

1Blink Strobe

   

6

 

1Blink (different timing than 5)

 

7

 

2 Blink Strobe

   

8

   

Solid On Landing

 

9

   

Solid On Landing

 

10

   

Solid On Landing

 

Each Output Channel Can be a Different Color

 

You can add more LED Lights on each Output (but they must be the same color)      

20 lights max (more if you have a 3 amp BEC)  10 on each output max

 

Easily Custom Configure your  lights ! Just Plug in your Led to the MaxiLight Kit

LED Lights must be within 2.0-3.7 Vf No resistors required - You must observe correct  polarization. All our LEDS work perfect and are pre wired

Connector spacing is .100 (standard header)

 

PRICE FOR STANDARD BOARD AS SHOWN  $29.00

For the female connectors and the Maxi Light board $32.95

 

 

Options

 

 LED Mounts/Diffuser Mounts in a .25 in hole

Green, Red, Yellow, or Clear Diffusers Just .50 each

Color

 

 

LIGHT KIT ACCESSORIES

Black LED mounts  Just .50 each